1. Measurement of streamflow



The measurement of streamflow, or discharge, is one of the most important aspects of practical hydrology. Because continuous direct measurement of streamflow is highly difficult and time-consuming, engineers universally adopt a two-step procedure:

  1. First, a relationship between the water surface elevation (called stage) and the discharge is established.
  2. Second, the stage of the stream is observed routinely, and the discharge is estimated using the previously determined stage-discharge relationship (rating curve).

To build this relationship, stage must be measured alongside discharge. Stage is defined as the water-surface elevation measured above a specific datum. It is measured using manual gauges, such as staff gauges (vertical, inclined, or sectional) and wire gauges, or via automatic recorders like the float-gauge recorder and bubble gauge.

The techniques for determining stream discharge are broadly classified into two categories: Direct determination and Indirect determination.

Direct Determination of Streamflow

Direct methods measure the flow velocity and flow area to calculate discharge. The main techniques include:

  • Area-Velocity Method: This is the most common method. The river cross-section is divided into a large number of sub-sections (verticals). The area of each sub-section is determined by measuring its width and depth, and the average velocity is measured using a current meter (a mechanical device with rotating cups or propellers). The total discharge is the sum of the discharges in all sub-sections.






  • Moving-Boat Method: Used for large rivers or when it is impossible to keep a boat stationary due to fast currents. A boat equipped with a special propeller-type current meter and an echo-depth recorder traverses the stream, measuring both the velocity and depth simultaneously.

  • Dilution Technique: This method relies on the continuity principle applied to a tracer (such as chemicals like common salt, fluorescent dyes, or radioactive materials) injected into the stream. The tracer is allowed to mix completely with the flow, and its concentration is measured downstream. It is particularly attractive for small, turbulent mountain streams where the area-velocity method is difficult to apply.



  • Electromagnetic Method: Based on Faraday's principle, this method treats water as a conductor. When water flows through a controlled magnetic field generated by buried coils, it induces a small voltage proportional to the flow velocity. It is highly suited for channels where properties change over time due to weed growth or sedimentation.


  • Ultrasonic Method: This uses ultrasonic signals transmitted diagonally across the channel between two transducers. The difference in the transit times of signals sent upstream versus downstream is used to calculate the mean flow velocity. This method is highly accurate, suitable for automatic recording, and can handle rapid changes in flow magnitude and direction, such as in tidal rivers.


Indirect Determination of Streamflow

Indirect methods utilize the relationship between flow discharge and river depths at specific locations, meaning only depth needs to be measured in the field.



  • Hydraulic Structures: Structures like weirs, flumes, and gated structures are built across the stream. These structures produce a unique head-discharge relationship (e.g., $Q = K H^n$), where the discharge ($Q$) is a function of the water surface elevation ($H$).


  • Slope-Area Method: This method is extensively used to estimate the magnitude of a flood peak after the flood has passed. It relies on high-water marks left by the flood to determine the water surface slope. By surveying the cross-sectional area and using a formula like Manning's equation, the flood discharge can be analytically estimated.




Map of the lecture for revision purposes.

























Comments

Popular posts from this blog

2. Factors affecting streamflow